Tools and Supplies Needed

5 minute epoxy
Low temperature hot melt glue and glue gun
Medium and fine sanding sponges
2" strapping tape
Soldering iron and solder
Allen wrenches to fit motor mount setscrews and servo pushrod connectors
Hobby knife
Drill with approximately .50 bit
Scissors
Needle nose pliers
Latex craft paint and brushes
Black Sharpie fine point
Ruler
Two micro servos and pushrod connectors
Micro radio receiver and crystal
- Recommended power: http://www.rchotdeals.com/
- ESC/motor combo = Towerpro Outrunner, brushless
2408-21 motor and HiModel HW series 18/22A ESC
Prop saver http://www.bphobbies.com/ for 3mm shaft
GWS EP-8040 Propeller
Shrink tubing
3 small servo screws for mounting the motor to firewall
Approximately 1000 mAh 3-cell Li-poly battery
Connectors